Dialogic Brooktrout TR1034 BRI Manual do Utilizador descarregar pdf (Página 31)

RightFax 8.5 Fax Board Guide 31

Testing Dialogic Boards

Before you can perform the fax board tests described in this section, you must configure the

RightFax software to communicate with the boards. For information on configuring RightFax to

work with your fax boards, refer to the chapter on configuring the RightFax BoardServer in the

RightFax Administrator’s Guide.

To test your Dialogic fax boards

This test lets you confirm that your Dialogic boards are installed and working properly and are

connected to working phone lines.

1. Open a command prompt on the RightFax server and enter the following command:

net stop rfboard

This stops the RightFax BoardServer service.

2. In the command prompt window, change to the RightFax\RFBoard folder.

3. Start the Dialogic service by entering the following command:

net start gammafax

4. When the Dialogic service is running, enter the following command:

sendfax ,,FaxNumber test001.tif ChannelNum

Where FaxNumber is the number of a working fax machine (including any prefixes necessary to

dial out of your phone system) and ChannelNum is the channel number to test.

If the test is successful, a test fax will arrive at the specified fax machine.

Checking the status of your fax channels

RightFax includes a utility that lets you ensure that the Dialogic drivers are running and properly

communicating with all of the channels configured in RightFax. This may also be useful in locating

channel problems.

To check the status of your Dialogic fax channels

1. Open a command prompt window and change to the RightFax\RFBoard folder.

2. Enter the following command:

ntspy.exe

The Ntspy program displays the real-time status of the configured Dialogic fax channels.

  

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sem comentários

Dialogic Brooktrout TR1034 BRI Manual do Utilizador Página 31