Dialogic Brooktrout TR1034 BRI Manual do Utilizador descarregar pdf (Página 12)

12 Chapter 1 Brooktrout Analog Fax Boards

Installing Brooktrout TruFax Boards

The Brooktrout TruFax series of analog fax boards consists of models with one or two loop-start

channels. Multiple TruFax boards can be installed on a single computer, but TruFax boards cannot

be used in combination with any other type of fax board. Instructions in this section apply to all

supported Brooktrout TruFax boards unless otherwise noted.

The following table lists all of the Brooktrout TruFax series fax boards supported by RightFax.

Setting the I/O address

This section applies to the ISA TruFax board only. You do not need to set an I/O address on either

the TruFax 100 PCI or TruFax 200 PCI.

Before installing ISA TruFax boards, you must manually set the base I/O address on each board.

The base I/O address is set on the board using switches 1 through 8 on the address selection dip

switch unit on the fax board. Refer to your Brooktrout documentation for the location of this unit on

your board.

Warning Do not use a pencil or any other object that conducts electricity to move the switches on the SW1

unit. Using graphite and other electrically conductive materials may cause severe damage to the board.

Each fax channel on the TruFax uses four consecutive I/O addresses. The address specified on the

address selector switch defines the base I/O address for the first channel. The second fax channel on

the board uses an address four greater than the first channel. For example, if the TruFax has its base

address set to 140, the two fax channels on the board will use addresses 140 and 144. If you have

multiple ISA TruFax boards installed, be careful not to assign overlapping I/O addresses.

Table 1D Supported Brooktrout TruFax Series Fax Boards

Board model Functionality

TruFax Two loop-start channel ISA analog fax board.

TruFax 100 PCI One loop-start channel PCI analog fax board.

TruFax 200 PCI Two loop-start channel PCI analog fax board.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sem comentários

Dialogic Brooktrout TR1034 BRI Manual do Utilizador Página 12