Dialogic Brooktrout TR1034 BRI Manual do Utilizador descarregar pdf (Página 24)

24 Chapter 3 Dialogic Analog Fax Boards

The following table lists I/O addresses and their switch settings for Dialogic board models whose I/

O addresses are set using three switches on the SW1 unit on the board.

Setting the board identifier

Each installed Dialogic CPi/200 PCI and CPi/400 PCI fax board must be assigned a unique board

identifier so the software can match the telephone numbers to the channels that reside on each

board. The unique board identifier is set using a rotary switch on the board.

To adjust the rotary switch, insert a small flat-head screwdriver in the arrow slot in the center of the

rotary switch. There are 16 available switch settings (from 0 to F hex). The arrow in the center of the

switch points to the current switch setting. Set each installed board to a unique switch setting.

Dialogic recommends setting the rotary switch before the board is installed. If you need to change

the board identifier after the board is installed, you must reboot the computer for the change to take

effect.

Installing Dialogic analog fax boards

Note For information on installing Dialogic CPD/220 fax boards, see ”Installing CPD/220 boards” on

page 25

Fax boards can be installed in the RightFax server or in a separate computer called a “remote

BoardServer.” For information on using remote BoardServers, refer to the RightFax Administrator’s

Guide.

After all of your Dialogic fax boards are configured to use unique I/O addresses, you are ready to

install them. Always turn your computer off before inserting or removing any board, and take all

necessary precautions to prevent static discharge when handling any fax board. Dialogic CP, CPi,

and CPi/100 boards can be installed into either an 8-bit or 16-bit slot. All other Dialogic CP series

boards must be installed in a 16-bit slot.

After the fax boards have been installed, refer to your Dialogic documentation for instructions on

connecting the phone cables.

Table 3C SW1 Unit I/O Address Switch Settings

Channel A I/O

address

Channel B I/O

address

Channel C I/O

address

Channel D I/O

address

Switch

350 360 370 250 Off Off Off

260 270 150 160 On Off Off

100 104 108 10C Off On Off

110 114 118 11C On On Off

280 284 288 28C Off Off On

290 294 298 29C On Off On

120 124 128 12C Off On On

130 134 138 13C On On On

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comentários a estes Manuais

Sem comentários

Dialogic Brooktrout TR1034 BRI Manual do Utilizador Página 24

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Dialogic Brooktrout TR1034 BRI