Dialogic Brooktrout TR1034 BRI Manual do Utilizador descarregar pdf (Página 14)

14 Chapter 1 Brooktrout Analog Fax Boards

After the fax boards are properly installed, refer to your Brooktrout documentation for instructions

on connecting the loop-start phone cables.

Completing the installation of your Brooktrout TruFax fax boards

After your Brooktrout TruFax fax boards have been installed, you should test the fax channels to

ensure that the boards have been properly configured and installed. For information on testing your

fax channels, see ”Testing Brooktrout Loop-Start Boards” on page 14.

When you have completed installing and testing your Brooktrout TruFax fax boards, you must

configure the RightFax software to communicate with the boards. For information on configuring

RightFax to work with your fax boards, refer to the chapter on configuring the RightFax

BoardServer in the RightFax Administrator’s Guide.

Testing Brooktrout Loop-Start Boards

After you have installed Brooktrout loop-start analog fax boards, you should test them to ensure

that the I/O addresses and hardware interrupts have been set properly and that faxes can be sent.

If the RightFax BoardServer service is running on the RightFax server, you must stop it before

performing these tests. To stop the BoardServer module, open a command prompt and enter the

following command:

net stop rfboard

Testing the I/O address settings

Note You do not need to run this program if you have installed Brooktrout TR1034 fax boards only.

If you have installed Brooktrout TR112, TR114, or TruFax boards, you must run the Faxinit program

to confirm that your fax board I/O settings are correct. This program scans the file Faxinit.cfg for I/

O addresses, and then checks those addresses for Brooktrout fax channels.

To test the fax board I/O address settings

1. Create a new text file called Faxinit.cfg on your RightFax server in the RightFax\RFBoard folder.

List the I/O addresses of your Brooktrout fax channels in the format:

addrs BaseI/0+4 NumChannels

where BaseI/0+4 is the base I/O address of the board plus four (to represent the first channel

on the board), and NumChannels is the number of channels on the board.

Example The following entry is used for a four-channel board with a base

I/O of 260:

addrs 264 4

2. After you have entered your fax channel I/O addresses for all installed Brooktrout fax boards,

save and close the file.

3. Open a command prompt and change to the RightFax\RFBoard folder on the RightFax server.

4. Enter the following command:

Faxinit Faxinit.cfg

The Faxinit program will confirm that the I/O addresses you entered in Faxinit.cfg correspond

to Brooktrout fax channels. If Faxinit.exe reports errors, you may have an address conflict. Check

the I/O addresses of each board and make changes if necessary.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Sem comentários

Dialogic Brooktrout TR1034 BRI Manual do Utilizador Página 14