Dialogic Brooktrout TR1034 BRI Manual do Utilizador descarregar pdf (Página 13)

RightFax 8.5 Fax Board Guide 13

The following table lists commonly used base address settings for TruFax fax boards. Using these

addresses may make it easier to prevent overlapping I/O addresses when you have multiple boards

installed.

Setting the hardware interrupt on the ISA board

Note This section applies to the ISA TruFax board only. You do not need to set a hardware interrupt on either

the TruFax 100 PCI or TruFax 200 PCI.

The ISA TruFax board requires you to configure an interrupt setting on each board. The interrupt

value is selected on the board using a jumper (which looks like a small plastic cap covering two

wires). Refer to your Brooktrout documentation for the location of the interrupt header on your

particular fax board model.

All ISA TruFax boards installed in the same computer must use the same interrupt setting. If a

TruFax board is already installed and operating, and you add another TruFax board, you must set

the hardware interrupt on the new board to the same value as the currently installed board.

You can use any interrupt setting that does not conflict with other devices on the computer. On

some computers, interrupt 3 may cause a conflict with the second serial port, and interrupt 4 may

conflict with the first serial port. If all of the TruFax boards are installed in 16-bit slots, interrupts 10,

11, and 15 are often your best choices.

Installing Brooktrout TruFax boards

Fax boards can be installed in the RightFax server or in a separate computer called a “remote

BoardServer.” For information on using remote BoardServers, refer to the RightFax Administrator’s

Guide.

After all of your TruFax boards are configured to use the proper I/O addresses and hardware

interrupt (if necessary), you are ready to install them. Always turn your computer off before

inserting or removing any board, and take all necessary precautions to prevent static discharge

when handling any fax board. The ISA TruFax board can be installed into either an 8-bit or 16-bit

slot in an ISA or EISA computer. The PCI boards can be installed in any PCI bus slot.

Table 1E TruFax Switch Settings for Commonly Used Base I/O Addresses

Base I/O

address

Switch

100 Off On Off Off Off Off Off Off

108 Off On Off Off Off Off On Off

110 Off On Off Off Off On Off Off

118 Off On Off Off Off On On Off

120 Off On Off Off On Off Off Off

128 Off On Off Off On Off On Off

130 Off On Off Off On On Off Off

138 Off On Off Off On On On Off

140 Off On Off On Off Off Off Off

148 Off On Off On Off Off On Off

150 Off On Off On Off On Off Off

158 Off On Off On Off On On Off

160 Off On Off On On Off Off Off

168 Off On Off On On Off On Off

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comentários a estes Manuais

Sem comentários

Dialogic Brooktrout TR1034 BRI Manual do Utilizador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Dialogic Brooktrout TR1034 BRI