Dialogic Brooktrout TR1034 BRI Manual do Utilizador descarregar pdf (Página 28)

28 Chapter 4 Dialogic Digital Fax Boards

Installing and Configuring the CPi/2400CT-T1 and CPi/3000CT-E1

These instructions will help you install and configure one or more Intel CPi/2400CT-T1 or

CPi/3000CT-E1 fax boards for use with a RightFax server. To install one or more of these fax boards,

complete all of these steps in the order they are listed.

Mount the fax boards in the server chassis

For information on the hardware requirements and physical installation of one or more

CPi/2400CT-T1 or CPi/3000CT-E1 fax boards, refer to the documentation provided by the board

manufacturer.

Install the fax server or remote BoardServer software

If it is not already installed, install either the RightFax server or remote BoardServer software on the

computer in which the fax boards are located. For information on installing the RightFax server and

running remote BoardServer software (which lets you operate fax boards from a computer other

than your RightFax server), refer to the RightFax Administrator’s Guide.

Install the fax board hardware drivers

Install fax board hardware drivers on all computers in which the fax boards are installed. This install

program is provided with your RightFax server software on a separate CD.

1. Insert the “Fax Board Driver Install” CD. If AutoRun is not enabled, run \RightFax\Setup.exe.

This starts the RightFax Hardware Module install wizard. Click Next at the introductory screen.

2. Enter your name and company name when prompted. Click Next.

3. In the Setup Type screen, select Complete and then click Next.

4. In the Fax Hardware Selection screen, select Dialogic, and then specify the DM3 models. Click

Next.

5. Click Install to begin the installation.

6. Click Finish to complete the RightFax Hardware Module install wizard.

7. When prompted, re-start the computer.

Configure the fax board firmware

1. After the computer re-starts, the GammaLink/Dialogic Configuration dialog box opens.

2. Select DCM Utility.

3. In the Computer Name dialog box, select Local and click Connect.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Sem comentários

Dialogic Brooktrout TR1034 BRI Manual do Utilizador Página 28