Dialogic 4000 SERIES Manual do Utilizador descarregar pdf (Página 42)

Dialogic

4000 Media Gateway Series Reference Guide

Page 42

General

You can configure the following parameters in the General section when you define or modify a route:

Name: Enter a unique name for the route, e.g., "Calls to MS Exchange Server".

Source: Select either the configured PSTN interfaces or SIP peer as a source. The route will only be

considered for a call if the call originated from a selected source.

You can select the same interface as a source and destination, e.g., if a call from the PSTN should

be routed back to the PSTN.

Calls arriving at disabled sources are immediately rejected without querying any route.

At least one source interface is required for the route.

Destination: The master or slave option in the dropdown menu allows for configuring priorities. Diva SIPcontrol

will always try to establish a call to one of the masters first and considers the slaves only if all

masters have failed or could not accept calls due to their call load.

Maximum call

attempts for this

route in a failover

scenario:

Enter the maximum number of destinations in a route that Diva SIPcontrol should call in a failover

environment. If you enter 0 (zero), Diva SIPcontrol tries all selected destinations. A value of 1

disables the failover functionality and tries only the first destination of a route.

If LDAP is used and the LDAP query requires various call attempts, this counts only as one call

attempt in a failover environment, because the LDAP queries are not counted as call attempts

here but in a different instance.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 167 168

Sem comentários

Dialogic 4000 SERIES Manual do Utilizador Página 42