Dialogic DSI SPCI Network Interface Boards Especificações descarregar pdf (Página 37)

Dialogic

DSI SPCI Network Interface Boards Programmer's Manual Issue 7

rai_gen

Description

Do not change RAI / Yellow alarm generation mode.

Disabled - do not generate RAI / Yellow alarm.

Forced active - generate RAI / Yellow alarm.

Automatic generation of RAI / Yellow alarm upon loss of

synchronization.

loop_mode

The diagnostic loop back mode taken from the following table:

loop_mode

Description

Do not change diagnostic loop back mode.

Disabled - remove any diagnostic loop.

Payload loopback.

Remote loopback.

Local loopback.

Status Response

The confirmation message (if requested) indicates success by status of zero.

On error, the following status values can be found in the confirmation message.

Value

Mnemonic

Description

0x01

None

Invalid framer ID.

0x02

None

Invalid message length.

0x03

None

Control parameters are not consistent with the type of device being

controlled or with each other.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 73 74

Sem comentários

Dialogic DSI SPCI Network Interface Boards Especificações Página 37