Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Manual do Utilizador descarregar pdf (Página 65)

d) Select the Single Computer option.

e) Use the DNS Lookup button and enter localhost in the appearing dialog, then validate.

The corresponding IP address appears now in the IP address field.

f) Click OK three times to validate and close the Properties dialog.

Start the service using the button.

The red mark should disappear from the node.

6. Configure XMediusFAX for relaying SMTP to IIS:

a) In the XMediusFAX administration interface, access the System Configuration ➤ [Host] ➤ SMTP

Gateway properties.

b) In the Mail Delivery Method section of the Gateway Settings tab, select the Relay to an SMTP

Server option.

c) In the Host Name field, enter the host name and port number corresponding to the IIS SMTP input:

According to the example used, the value should be: localhost:2525.

Note: Authentication is no more needed here, as IIS and the Fax Server are on the same machine.

d) Click OK to validate.

IIS and XMediusFAX are now configured for using TLS on SMTP in output.

If you wish to test this configuration, see Testing the SMTP TLS Output Configuration on page 56.

If you wish to configure IIS for SMTP TLS in Input, in addition to the configuration you just made, see

Configuring IIS for SMTP TLS in Input on page 56.

XMediusFAX | Installation and Maintenance Guide 55

Chapter 6 | SMTP Integration

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 101 102

Sem comentários

Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Manual do Utilizador Página 65