Dialogic M7324 Manual do Utilizador descarregar pdf (Página 138)

Dialogic

PBX Integration Board User’s Guide

The parameter list for batch mode is:

• /s=<ext1>-<ext2> : this field is required. Specify the beginning extension

(ext1) and the ending extension (ext2).

• /b=<port to use> : this field is required. Extbuilder will use this port to

call out.

• /donis : this field is optional. If specified and if extbuilder receives a “Not

in Service Number” message from the PBX, then the given entry is

removed from the configuration.

• /doin : this field is optional. If specified and if extbuilder receives an

“Invalid Number” message from the PBX, then the given entry is

removed from the configuration.

In both interactive and batch mode, the extbuilder has the following

limitations:

• If a D82/D42 port is specified, extbuilder will use that port to call out to

the destination phone to determine the phone’s label.

• The destination phone’s call forwarding feature should not be enabled

during that time. Extbuilder can determine the phone’s label, even with

call forwarding enabled, but this is not guaranteed for this scenario.

• The destination phone cannot be the source phone, if a D82/D42 port is

specified.

• There is no locking mechanism. Only one instance of extbuilder can be

executed at any given time.

138

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 177 178

Sem comentários

Dialogic M7324 Manual do Utilizador Página 138